2012-01-23, 23:57
Hi. I have an embarrassing problem. I'm sure it should be so easy, but I'm blatantly struggling to even get off the ground.
I have installed Python 3.2.2 and XBMC on a 64-bit Windows 7 laptop, and downladed Voinage's tutorial here.
I loaded up IDLE(Python GUI), open Default.py, hit F5, and none of the print commands with double quotes worked, so I commented them out.
Then I hit F5 again, and urllib2 couldn't be found, so I removed it.
Then I hit F5 again and xbmcplugin couldn't be found.
Same goes for xbmcgui
Can anyone tell me where I'm going wrong?
I have installed Python 3.2.2 and XBMC on a 64-bit Windows 7 laptop, and downladed Voinage's tutorial here.
I loaded up IDLE(Python GUI), open Default.py, hit F5, and none of the print commands with double quotes worked, so I commented them out.
Then I hit F5 again, and urllib2 couldn't be found, so I removed it.
Message was ImportError: No module named urllib2
Then I hit F5 again and xbmcplugin couldn't be found.
Same goes for xbmcgui
Can anyone tell me where I'm going wrong?