Video calibration reset when switching HDMI input off and on

  Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Post Reply
slantedview Offline
Junior Member
Posts: 24
Joined: Dec 2012
Reputation: 0
Post: #1
I am running Frodo RC2 on my Foxconn nt-a3700 being served by an HDMI input, and I noticed that when I turn off the HDMI signal (turn off my receiver) then turn it back on, the video on my XBMC loses its calibration. The only fix is to recalibrate or reboot my XBMC box. Is this a bug?

ALSO, I've noticed that calibration appears to not be saved exactly. I'll calibrate, adjusting the blue bars perfectly. Then if I go right back in and recalibrate, the blue bars are usually off by a few pixels in different directions (it appears random). I can fix them, but then the same thing happens next time. Is this a bug?
(This post was last modified: 2012-12-26 21:30 by slantedview.)
find quote
Ned Scott Offline
Posts: 31,464
Joined: Jan 2011
Location: Arizona, USA
Post: #2
debug logs (wiki) needed...
find quote