[SleepyP]

how does this script compare with the KAI gui built into XBMC? i'm not happy with the built in GUI in its current state.

[Nuka1195]

The script isn't the same thing.

It just starts and stops the kai daemon on your router.

[hgouveia]

well. i downloaded the script. and finally works. but. other error comes. it said CfgFile.xml invalid or missing . i put my router ip. and the firmware version too..

[Nuka1195]

did you change your password?

[hgouveia]

yes.. i put the password that i used for the router ..

[hgouveia]

i see. that you are online now.. do you have Msn Messenger for talk about this. and resolve this problem , here is my msn. [email protected]

[Nuka1195]

did you edit it manually or by pressing the white button and did you save it by pressing the white button.

It sounds like the changes are not saving.

[hgouveia]

i did press the white button and when i finish to configure all. i press the white button again to saves changes

[Nuka1195]

The only time you should get that message is if the IP or password is wrong.

Edit CfgFile.xml manually and see if that works.

[hgouveia]

the same... i have a Linksys WRT54GL with Firmware: DD-WRT v23 SP1 Final (05/16/06) std. and the router ip its 192.168.0.1 i put all in the CfgFile.xml and the same thing..

[Nuka1195]

self.COMMAND_RETURN = (self.open("http://" + router_ip + "/apply.cgi", parameter))

Look down about line 298 and change that line with the above. Make sure the indentation stays the same.

[hgouveia]

the same...

[Nuka1195]

what firmware selection do you have set?

[hgouveia]

3 DD-wrt.

[Nuka1195]

http://192.168.0.1/Command.asp

type that in your browsers address bar and enter your password. Then view source and paste that text at pastebin and post the link.