Posts: 15
Joined: May 2016
Reputation:
0
Tygerr
Junior Member
Posts: 15
Hi all,
I was watching a movie when the power was cut. the device was started afterwards but when i started the movie there was no audio anymore.
Its a analog audio port, im running Jarvis 16.1.
I tried the setting and reboot multiple times, also turning off input devices but i still come up empty.
Anyone?
Posts: 15
Joined: May 2016
Reputation:
0
Tygerr
Junior Member
Posts: 15
Just found out this was a hardware problem. replaced the main board and its running fine again after tweaking the settings again.
There is no sound test button so i turned on the clicking sound to test.
Posts: 39
Joined: Dec 2010
Reputation:
0
bdoe
Junior Member
Posts: 39
Sounds like your sound hardware was taken out by a power surge when your power got cut. Now's a good time to invest in a surge protector.
Posts: 15
Joined: May 2016
Reputation:
0
Tygerr
Junior Member
Posts: 15
No it was taken out by a defect usb port, it shorted.
But after replacing the hardware i got the same problem, I did a audio reset to default and rebooted. Still nothing. i restarted the tv and it was working. weird.
Posts: 23,266
Joined: Aug 2011
Reputation:
1,074
fritsch
Team-Kodi Developer
Posts: 23,266
If no TV is present at boot -> no audio as the handshake does not happen.
You can only force the EDID of the connector or make sure that your TV is on whenever you start the computer.
First decide what functions / features you expect from a system. Then decide for the hardware. Don't waste your money on crap.