2008-10-08, 04:42
Hello.
I'm very excited to see if I can get this working, and I'm greatly impressed with the amount of support and interests on this board...but...
I installed xbmc beta 2 on my ATV manually (as I use nitoTV for things) and all went swimmingly. App showed up, I can configure keymap etc, but when the XBMC app loads - It first flashes something about 'encountered an error' and then a smaller window pops up over the top with the XBMC logo which fades to the menu.
The main problem is that I cannot control anything. Nothing responds once the XBMC 'main menu' shows up (and it's not frozen, since the RSS feed still scrolls along the bottom.
Frankly, I'm psyched to get this far, but is there any advice for this issue?
Thanks!!
### EDIT
Found the problem - Had symlinks all hosed up. Make sure she's-a-pointing to the right place. (ha!)
I'm very excited to see if I can get this working, and I'm greatly impressed with the amount of support and interests on this board...but...
I installed xbmc beta 2 on my ATV manually (as I use nitoTV for things) and all went swimmingly. App showed up, I can configure keymap etc, but when the XBMC app loads - It first flashes something about 'encountered an error' and then a smaller window pops up over the top with the XBMC logo which fades to the menu.
The main problem is that I cannot control anything. Nothing responds once the XBMC 'main menu' shows up (and it's not frozen, since the RSS feed still scrolls along the bottom.
Frankly, I'm psyched to get this far, but is there any advice for this issue?
Thanks!!
### EDIT
Found the problem - Had symlinks all hosed up. Make sure she's-a-pointing to the right place. (ha!)