[woodjb]

Hi there. Up until recently, my setup has been a full Ubuntu distro with xbmc on top. Due to various reasons, I was never able to get networking fully operational in standalone mode.

Now, I switched to XBMC live. I've been using this guide to get my AE1000 working: http://forums.fedoraforum.org/showthread.php?p=1353558
The kernel module (and interface) are both ra0 after doing that guide. I have a home wireless network with WPA2, where do I put that information so it connects quickly at boot?

Thanks in advance.

[woodjb]

Took a loooooot of forum hopping and link clicking, but I found this:

http://ubuntuforums.org/showthread.php?t=202834

Replace wlan0 with ra0 and you're good to go.