Solved Problem with VRC-1100 Remote - Printable Version +- Kodi Community Forum (https://forum.kodi.tv) +-- Forum: Support (https://forum.kodi.tv/forumdisplay.php?fid=33) +--- Forum: General Support (https://forum.kodi.tv/forumdisplay.php?fid=111) +---- Forum: Linux (https://forum.kodi.tv/forumdisplay.php?fid=52) +---- Thread: Solved Problem with VRC-1100 Remote (/showthread.php?tid=217940) |
Problem with VRC-1100 Remote - wripet - 2015-02-10 Hi, I'm having troubles getting the VRC-1100 IR Remote to work. Plugged it in, lsusb showed that the device was seen by the system. I installed lirc and inputlirc, but after the installation, I'm having problems get lirc to start. Code: main@htpc:~$ sudo service lirc stop When the system boots, I can see a few blinks on the IR receiver, but then I get the same message and lirc fails to start. lsusb gives Code: Bus 002 Device 002: ID 05a4:9881 Ortek Technology, Inc. IR receiver [VRC-1100 Vista MCE Remote Control] My system: Code: main@htpc:~$ uname -r Code: main@htpc: apt-show-versions lirc RE: Problem with VRC-1100 Remote - wsnipex - 2015-02-10 you shouldn't need lirc at all, the remote registers as HID device and normally works ootb. Some buttons will need keymappings in kodi though. Problem with VRC-1100 Remote - wripet - 2015-02-10 (2015-02-10, 15:18)wsnipex Wrote: you shouldn't need lirc at all, the remote registers as HID device and normally works ootb. Some buttons will need keymappings in kodi though. Ok, I'll try again asap. RE: Problem with VRC-1100 Remote - wripet - 2015-02-11 Thanks, working out of the box. As you said, no lirc or anything required. |