ExternalPlayer -vo mpegpes via FF DVB-S Card - Printable Version +- Kodi Community Forum (https://forum.kodi.tv) +-- Forum: Support (https://forum.kodi.tv/forumdisplay.php?fid=33) +--- Forum: General Support (https://forum.kodi.tv/forumdisplay.php?fid=111) +---- Forum: Linux (https://forum.kodi.tv/forumdisplay.php?fid=52) +---- Thread: ExternalPlayer -vo mpegpes via FF DVB-S Card (/showthread.php?tid=65173) |
ExternalPlayer -vo mpegpes via FF DVB-S Card - jcbmania - 2009-12-27 Hi, I still have to use my old Tube-TV, so my best picture is to send all video streams to the card which gets me a fine RGB signal to the good old tube. Using a new installed mplayer, works almost perfect on the cmd-line. Now I want to start this as ExternalPlayer through XBMC. The video starts, but I cannot control the mplayer anymore. Is this normal or did I made something wrong? Also, is there maybe a way of configuring the internal default video player to use the DVB Card as output when I compile by myself? So that every played video goes to the card? This I would use then until I can buy a Flat TV My Setup: POV 330-1 ION Technotrend WinTV DVB-S rev1.5 XBMC 9.11(live): Camelot through a RC1 upgrade Code: <playercorefactory> Any hints would be fine, or even the light @ the end of the tunnel. Thanks JCB - daledude - 2009-12-27 If your using a remote control with lirc then you will need to add key assignments to your .lircrc in your home directory for mplayer to work. There are quite a few posts in the forum that should help you out. - jcbmania - 2009-12-27 Hi daledude, thanks for that. I just thought, there is another way, cause many others have used external players, but never mentioned that. So I hoped xbmc routes the commands to the client it just started. Thanks for Your help. I will try that. JCB |