2014-04-01, 19:19
Hello guys! I need some help and this is NOT a joke (April's 1st)!
Setup:
- I have an Arduino One R3 loaded with Adalight code http://learn.adafruit.com/adalight-diy-a...nd-install
- I have a WS2801 LED strip with 72 chips/channels, each chip controls 3 LED's (216 LED, 72 ch.)
- Testing the entire stream with a color swirl code, all LED's are working perfectly and each chip is addressed properly.
- Installed boblight with no errors, XBMC shows "Connected to Boblight".
- Using the interface that "Hansaplast" beautifully developed, I set the config exactly as per my setup: 11+11 channels bottom, 14 ch left and right and 22 ch up, clockwise. The com speed is the same as per Arduino code, 115200
- The generated conf file is http://pastebin.com/SCN8KhRn
- I put into rc.local before the "exit 0" the following:
chmod 777 /dev/ttyACM0
sleep 5
su - htpc -c "boblightd -f"
Problem: It works only the first bottom-half and the left side, about 1/4 of the entire LED strip (25 channels). I tried with few config but no success. Please help. Once again: the entire LED strip works fine and each chip could be addressed (tested with colour swirl pde).
Note: I was unable to run the "Boblight Config Maker" in Ubuntu 12 (where/how to install it and how to run it?) so I ran it on my mac where I generated the config file.
.... to add more info:
I believe that boblight connects fine, here is the boblight.log from ".boblight" folder: http://pastebin.com/4q7pZSjs
And here the snapshot before creating the conf file. http://imgur.com/NR762dv
Setup:
- I have an Arduino One R3 loaded with Adalight code http://learn.adafruit.com/adalight-diy-a...nd-install
- I have a WS2801 LED strip with 72 chips/channels, each chip controls 3 LED's (216 LED, 72 ch.)
- Testing the entire stream with a color swirl code, all LED's are working perfectly and each chip is addressed properly.
- Installed boblight with no errors, XBMC shows "Connected to Boblight".
- Using the interface that "Hansaplast" beautifully developed, I set the config exactly as per my setup: 11+11 channels bottom, 14 ch left and right and 22 ch up, clockwise. The com speed is the same as per Arduino code, 115200
- The generated conf file is http://pastebin.com/SCN8KhRn
- I put into rc.local before the "exit 0" the following:
chmod 777 /dev/ttyACM0
sleep 5
su - htpc -c "boblightd -f"
Problem: It works only the first bottom-half and the left side, about 1/4 of the entire LED strip (25 channels). I tried with few config but no success. Please help. Once again: the entire LED strip works fine and each chip could be addressed (tested with colour swirl pde).
Note: I was unable to run the "Boblight Config Maker" in Ubuntu 12 (where/how to install it and how to run it?) so I ran it on my mac where I generated the config file.
.... to add more info:
I believe that boblight connects fine, here is the boblight.log from ".boblight" folder: http://pastebin.com/4q7pZSjs
And here the snapshot before creating the conf file. http://imgur.com/NR762dv