[Suven]

Hi!

I just plugged my Adalight-Setup into my XBMCBuntu-HTPC the first time and am running into some problems.

What I did so far:
Using my mac I installed the image in Adruino IDE and tested my stripes (I have 50 LEDs) with Processing and the ColorSwirl-Programm.. Since that worked nicely I attached everything to said HTPC.

I compiled and installed boblight from their SVN (Revision 400) and created my boblight.conf: http://pastebin.com/H70xSDY0

Then to test this, I rebooted, started boblightd and without running xbmc I started boblight-constant FF0000 from another terminal.

What happens is that when I start boblightd, the LEDs blink red, green, blue and after this nothing happens.

Code:

(InitLog)                       start of log /home/sven/.boblight/boblightd.log
(PrintFlags)                    starting boblightd
(CConfig::LoadConfigFromFile)   opening /etc/boblight.conf
(CConfig::CheckConfig)          checking config lines
(CConfig::CheckConfig)          config lines valid
(CConfig::BuildConfig)          building config
(CConfig::BuildConfig)          built config successfully
(main)                          starting devices
(CClientsHandler::Process)      opening listening socket on 127.0.0.1:19333
(CDevice::Process)              ambilight: starting with output "/dev/ttyACM0"
(CDevice::Process)              ambilight: setting up
(CDevice::Process)              ambilight: setup succeeded
(CClientsHandler::Process)      127.0.0.1:48428 connected
(CClientsHandler::ParseMessage) 127.0.0.1:48428 said hello
(CClientsHandler::ParseSet)     127.0.0.1:48428 priority set to 128

None of the LEDs is on.

I already made sure that /dev/ttyACM0 is the right output-device by watching tail -f /var/log/syslog

Code:

Jun 10 17:50:39 xbmc kernel: [ 1491.240018] usb 4-3: new full speed USB device number 6 using ohci_hcd
Jun 10 17:50:39 xbmc kernel: [ 1491.473458] cdc_acm 4-3:1.0: ttyACM0: USB ACM device

Does anybody know what else I can do? ._.