WIP Stereoscopic 3D support for half/full SBS, over/under, etc
Hi Guys

Been testing 3D playback for a while through all the different versions of Openelec since Gotham was released. I seem to have found a slight problem when displaying half over/under files on a passive tv. The image appears to be shitfted up by a few pixels which makes part of the top of the image appear on the bottom.

The film is Monsters University and is half o/u. My preferred mode is Over/Under and I have the display set to adjust refresh to match video.

My TV is an LG 55LM760T and is set to "Just Scan". The native resolution and resolution in XBMC is 1920x1080.

When I initially play back the file (before switching the TV to 3D mode) I can see that the top pixels seem to be cut off as below:


Here's a closer image of the top of the screen:


And this is a picture I took of the display in 3D mode:


As you can see the image appears to be slightly shifted up.

I did notice that when I change the resolution in XBMC to 1366x768 the issue goes away.

I've ran mediainfo on the file and uploaded the results to pastebin


I'm not sure if this is a bug or a problem with my setup can anyone point me in the right direction.


Messages In This Thread
Intel® InTru™ 3D support - by acidizer - 2014-01-26, 12:47
RE: Stereoscopic 3D support for half/full SBS, over/under, etc - by brownbear1984 - 2014-08-17, 05:03

Logout Mark Read Team Forum Stats Members Help
Stereoscopic 3D support for half/full SBS, over/under, etc11
This forum uses Lukasz Tkacz MyBB addons.