2012-12-28, 18:34
I do use Windows Firewall, but I created a little BAT file using the commands from the Firewall Settings Wiki (to reduce finger typos) and all commands completed with the OK message.
Now, I seem to have a new problem.
Notice in the image below that all of my TV cards pulled up this morning saying their Type was Unknown. If I tried to scan a channel using Manual Control or Test Channels, I got that No Card error.
So, in my infinite wisdom, I simply removed the 4 cards with the intention of adding them again later.
Now, TV Server Config will not even start - I'm guessing because there are no cards available.
I uninstalled MediaPortal, did a reboot of my PC, then reinstalled MediaPortal.
TV Server Config still refuses to start.
How do I get the cards added back into TV Server?
Now, I seem to have a new problem.
Notice in the image below that all of my TV cards pulled up this morning saying their Type was Unknown. If I tried to scan a channel using Manual Control or Test Channels, I got that No Card error.
So, in my infinite wisdom, I simply removed the 4 cards with the intention of adding them again later.
Now, TV Server Config will not even start - I'm guessing because there are no cards available.
I uninstalled MediaPortal, did a reboot of my PC, then reinstalled MediaPortal.
TV Server Config still refuses to start.
How do I get the cards added back into TV Server?
