[MrHenky]

I can't get boblight to work!
im running on windows 8 with 50 ws2801 hooked up to an arduino uno.
when i start boblight the colorswirl goes of and it says setup succeeded but after that i can't get it working. neither via xbmc plugin or via bobdroid.

here is my boblight.conf
i set the output to com3 (which is correct)
is the channels and type correct?

Code:

#[global]
interface    127.0.0.1
port        19333

[device]
name        ambilight
output     /dev/com3
channels    150
type        atmo
interval    10000
prefix        FF
rate        115200

[color]
name        red
rgb            FF0000
gamma        0.91
adjust        1.0
blacklevel    0.0

[color]
name        green
rgb            00FF00
gamma        0.86
adjust        0.96
blacklevel    0.0

[color]
name        blue
rgb            0000FF
gamma        0.95
adjust        0.8
blacklevel    0.0

also here is the output of the boblight window with me starting xbmc (xbmc saying boblight connected) and then starting a movie...

any ideas whats wrong

Your prefix is wrong. This should do it, I guess: 416461003164

Also, you should configure 150 LEDs, not only 50. (Red, Green, Blue)

Use this calculator:
http://sanya.tarhelyszolgaltato.eu/

And read here:
http://forum.xbmc.org/showthread.php?tid=116331&pid=1059881#pid1059881