2014-11-05, 19:24
Updated Helix build, Kodi master from Nov 04 + newclock4 commits.
Kodi Master:
• Master changelog
Newclock4 additions:
• [cec] Temp - more logging
• [cec] Don't discard buttons when repeat mode is enabled
Libcec additions:
• Pass through duration on all button repeats
• Skip double press removal. It is handled through other means.
• Support repeating button presses with configurable repeat rate
• Keep track of time since initial button press and last button update (included in last two builds)
• Make released key polling wait for exact time until key gets released (included in last two builds)
Additional:
• Upstart job now back to ’xbmc’. Should hopefully fix issues with other daemons such as eventlircd, avahi (+ Airplay), tvheadend etc.
• Updated the enable-kodi + the watchdog scripts to be compatible with recent changes in master
GPU firmware from Nov 04 included:
• firmware: config: Make framebuffer_swap and framebuffer_ignore_alpha enabled by default
NB! To be able to run this build you must first run enable-kodi*.sh as explained here!
For this build you will need the new enable-kodi2 script:
To install Kodi build, SSH to Pi (first run ’sudo sh enable-kodi2.sh’ if not already enabled):
See post #1 for more info
Kodi Master:
• Master changelog
Newclock4 additions:
• [cec] Temp - more logging
• [cec] Don't discard buttons when repeat mode is enabled
Libcec additions:
• Pass through duration on all button repeats
• Skip double press removal. It is handled through other means.
• Support repeating button presses with configurable repeat rate
• Keep track of time since initial button press and last button update (included in last two builds)
• Make released key polling wait for exact time until key gets released (included in last two builds)
Additional:
• Upstart job now back to ’xbmc’. Should hopefully fix issues with other daemons such as eventlircd, avahi (+ Airplay), tvheadend etc.
• Updated the enable-kodi + the watchdog scripts to be compatible with recent changes in master
GPU firmware from Nov 04 included:
• firmware: config: Make framebuffer_swap and framebuffer_ignore_alpha enabled by default
NB! To be able to run this build you must first run enable-kodi*.sh as explained here!
For this build you will need the new enable-kodi2 script:
Code:
wget http://goo.gl/G4EG8M --no-check-certificate -O enable-kodi2.sh
sudo sh enable-kodi2.sh
To install Kodi build, SSH to Pi (first run ’sudo sh enable-kodi2.sh’ if not already enabled):
Code:
wget -O kodi-14-20141105-nc4.tar.gz http://goo.gl/ZzwdnB --no-check-certificate
pv kodi-14-20141105-nc4.tar.gz | tar xzf - -C /home/pi/.upgrade
sudo cp /home/pi/.upgrade/kodi-14-20141105-nc4/{fixup_x.dat,start_x.elf} /boot
ln -sfn /home/pi/.upgrade/kodi-14-20141105-nc4/xbmc-bcm /home/pi/.xbmc-current
sudo reboot
See post #1 for more info