[Warner306]

hmm, not much activity or help on the displayCAL forum, i'll have to ask on here until I can get back into DOOM9 and ask on the MADVR gen thread.

When I setup my TV for calibration, I reset the profile to defaults, the picture looks fine, no issues. I then also set black clipping pattern to 17 flashing to get everything roughly ok. I start DISPLAY CAL, When I measure my white balance its way off, green is very high and blue/green a bit low, i also tested this with an older DP24 and my mobile phone camera, all report high greens, thing is picture looks fine to me, black bars in clipping pattern are perfectly grey, if I turn the green down they start to go red, I guess the green could be mainly in the higher luminance?

When I say green is high, I have to take it down to -13 or more and take blue/red up for 6 pointes to even the bars out, does this sound really off or could this be fairly normal does anyone think?

Are there any settings I should definately choose for calibrating an OLED with an ageing SPYDER2 - (getting something better shortly hopefully)

If your white balance is way off, then your default calibration is not set close enough to D6500, or your meter is inaccurate. Make sure you have the correct meter profile selected in DisplayCal with the correct corrections for the meter.

To get the white balance close enough to create a 3D LUT, you should be able to input the basic settings for your display from RTINGS.com. Disable the 10-point and 2-point white balance controls, set color to 50 and tint to 50, because they settings are almost always correct from the factory, and determine what color temperature is closest to D6500 by looking at the setting used by RTINGS.com. The Delta E of your white balance should be somewhere close to 3, I would think.

You don't want to touch the white balance controls before creating the 3D LUT.