2017-09-12, 17:21
I've still never seen this "error" using current or older drivers? What exactly is the error or errors? What happens or doesn't happen? Is there a pop-up window when it occurs? Provide some details about your hardware and the software versions you are using. Perhaps a snapshot or video. Detail some pertinent settings. Install techniques, etc. From what I've read, one of you has no right click context menu for NCP and cannot access it by other means, another simply can't get 3D to engage, and the last is not presented with a stereoscopic setup when 'Enable stereoscopic 3D' is ticked. While these are all problems for what ever reasons, they are not "same" things. You guys have mentioned "3D Wizard". Why are you selecting 3D Wizard? When you install drivers, 3D stereoscopic is always disabled in the NCP (NVidia Control Panel) no matter what it was previously set to prior to updating. I assume you are always updating using the clean install option. When you check that 3D option, you shouldn't have to do anything else. The 3D setup automatically starts and you make your selections. If you aren't even presented with a control panel much less the stereoscopic setup, your driver install is seriously messed up. You've got conflicts or residuals preventing it from installing correctly imo. Driver installation failure using a new install of the O/S makes no sense? If this were the case, I think it would be a widespread reported problem all over the place especially NVidia forums. Searches reveal no other reports except yours though?