2016-02-04, 09:56
The problem is that only S9 (and future) devices will make use of those new resolution names and the only way to detect it is checking the presence of HEVC 10-bit decoding since cpuinfo is not very helpful on S9 (at least yet).
You can't check the resolution values from the hdmi driver because it's not guaranteed that one of the new resolutions is listed, it's unlikely but might happen (in case of a bad EDID probably)
I can set it as a method and call it like "needsNewResolutions", or anything else
You can't check the resolution values from the hdmi driver because it's not guaranteed that one of the new resolutions is listed, it's unlikely but might happen (in case of a bad EDID probably)
Code:
Processor : AArch64 Processor rev 4 (aarch64)
processor : 0
processor : 2
processor : 3
Features : fp asimd crc32 wp half thumb fastmult vfp edsp neon vfpv3 tlsi vfpv4 idiva idivt
CPU implementer : 0x41
CPU architecture: 8
CPU variant : 0x0
CPU part : 0xd03
CPU revision : 4
Hardware : Amlogic
I can set it as a method and call it like "needsNewResolutions", or anything else