[billbillw]

Guys,
I can't figure out what I need to do to get my NUC7i3BNH to passthrough DTS-HD MA and TrueHD/ATMOS using LibreElec. (I don't have any DTS-HRA)
I've tried the latest Official Release (8.2.5) and I've tried a few different Milhouse 9.0 releases, including the latest (#0505). I've read through some of this thread, but I'm trying to avoid reading all 70 pages. 

Are there any LibreElec releases that will allow the NUC7i3 to passthrough/bitstream the lossless audio tracks? I am not seeking 4K, 3D, or HDR playback. I don't have any HDMI2.0 displays. I mostly only playback 1080p bluray rips (or lower resolution) from my collection and I wanted more powerful hardware to handle H265 encoded material that I've started using. I don't use "sync display", but I like to use "Adjust display refresh rate" on Start/Stop. I've had this working before on lesser hardware (Haswell Chromebox and AMD G-T48E based thin client) so I know how the settings should be set.
EDIT: I am using a Yamaha A3010 receiver (NOT HDMI 2.0), not sure if that matters.

If the only way to do it is through Windows Kodi, I will do that, but I'd prefer to keep it with LibreElec only for speed/reliability.

So, it took me longer than expected, but I was able to get a full Windows 10 install running, and tried Kodi (I used a 'snapshot' nightly from April). Everything works, DTS-HD Master, Dolby TrueHD/ATMOS, and it works with display refresh rate changing to match source as well. I guess I will have to run Windows to get what I want for now. Hopefully with a few kernel/driver improvements, LibreELEC will work again. I much prefer LibreELEC. 

Note: I did update the HDMI Firmware to version 1.66 for the NUC7i3BNH, and also, you can update the firmware even if only connected to an HDMI 1.4 display. You just have to make sure the Intel display drivers and chipset drivers are installed before trying to update.