2019-10-29, 12:49
Hi all,
I am trying to set up my IR remote.
ir-keytable shows that ir-6 kernel protocol is not enabled (only lirc is listed in Enabled Kernel Protocol section):
$ sudo ir-keytable
Found /sys/class/rc/rc0/ (/dev/input/event5) with:
Name: Media Center Ed. eHome Infrared Remote Transceiver (1934:5168)
Driver: mceusb, table: rc-rc6-mce
LIRC device: /dev/lirc0
Supported kernel protocols: lirc rc-5 rc-5-sz jvc sony nec sanyo mce_kbd rc-6 sharp xmp imon
Enabled kernel protocols: lirc
bus: 3, vendor/product: 1934:5168, version: 0x0001
Repeat delay = 500 ms, repeat period = 125 ms
This remote works on another machine whose Enabled kernel protocol has both "lirc" and "rc-6".
How do I enable rc-6 kernel protocol?
I am trying to set up my IR remote.
ir-keytable shows that ir-6 kernel protocol is not enabled (only lirc is listed in Enabled Kernel Protocol section):
$ sudo ir-keytable
Found /sys/class/rc/rc0/ (/dev/input/event5) with:
Name: Media Center Ed. eHome Infrared Remote Transceiver (1934:5168)
Driver: mceusb, table: rc-rc6-mce
LIRC device: /dev/lirc0
Supported kernel protocols: lirc rc-5 rc-5-sz jvc sony nec sanyo mce_kbd rc-6 sharp xmp imon
Enabled kernel protocols: lirc
bus: 3, vendor/product: 1934:5168, version: 0x0001
Repeat delay = 500 ms, repeat period = 125 ms
This remote works on another machine whose Enabled kernel protocol has both "lirc" and "rc-6".
How do I enable rc-6 kernel protocol?
