2015-12-30, 20:26
Ok, tested this Kodi, and installed it over the existing. Hope thats not a factor.
Anyway i dont get Atmos and i dont get DTS master to show up on my reciver, so for me this did not do the trick so far.
I have enabled pasthorug and everything as postetd on side 1. but no Luck.
My setup is a Beelink r68 With Hdmi to my Denon X4100 wich totally play Atmos and dts master With no problem from other Sources like my Mede8er.
But not from this andoid Box.
I have set hdmi to bitstream in setting at the Box itself so it should read the sound.
But where it says "audio output Device" I can see some of you can see Your reciver, but mine is greyed out and it only says "android, Audiotrack."
When i enable passthrough i get this loss of sound every 6-7 Seconds just for a few milliseconds but i can see the reciver reacts to it and the speakersymbols on my reciver Dashboard is blinking every time that happens.
I am a little lost here as for now.. Any suggestions to try?
I have tried a ATMOS media file wich i can play With my mede8er and then it totally makes my house rumble, but playing the same file With this beelink is not giving a great sound and my subs bearly move.
The surround effect also is really poor and its not "around me" as it is when playing from the Mede8er.
Thanks for helping me out!
Anyway i dont get Atmos and i dont get DTS master to show up on my reciver, so for me this did not do the trick so far.
I have enabled pasthorug and everything as postetd on side 1. but no Luck.
My setup is a Beelink r68 With Hdmi to my Denon X4100 wich totally play Atmos and dts master With no problem from other Sources like my Mede8er.
But not from this andoid Box.
I have set hdmi to bitstream in setting at the Box itself so it should read the sound.
But where it says "audio output Device" I can see some of you can see Your reciver, but mine is greyed out and it only says "android, Audiotrack."
When i enable passthrough i get this loss of sound every 6-7 Seconds just for a few milliseconds but i can see the reciver reacts to it and the speakersymbols on my reciver Dashboard is blinking every time that happens.
I am a little lost here as for now.. Any suggestions to try?
I have tried a ATMOS media file wich i can play With my mede8er and then it totally makes my house rumble, but playing the same file With this beelink is not giving a great sound and my subs bearly move.
The surround effect also is really poor and its not "around me" as it is when playing from the Mede8er.
Thanks for helping me out!