Posts: 1,897
Joined: Feb 2013
Reputation:
128
this fix is uncluded the latest builds.
Posts: 68
Joined: Feb 2018
Reputation:
10
Ok, thanks for checking and very fast reply! Seems I have to stick to the Decemebr 2016 build.
Posts: 19
Joined: Jan 2017
Reputation:
0
Hello and thanks for the good work.
I'm new to this Build.
Can it work on my HTPC i3-4160?
How can I know what drivers I need for that?
Is this Build will change my kodi version?
Thanks in advance.
Posts: 5,147
Joined: Dec 2011
Reputation:
181
To @movie78's point, try the build in post #1, making the recommended setting, as is w/your current Intel HD graphics driver. Should work... only need to seek alternate driver if 3D doesn't look right to you (namely ghosting, not as sharp or objects in different planes looking off).
Posts: 45
Joined: Mar 2013
Reputation:
1
Hello,
Setup a win10 beelink ap34 a few months back; and found the most stable of the windows builds for 3D was KodiSetup-20161208-2e764f6. All of the later builds (up to the Dec 2017 build) had very poor dts performance, and most 3D movies with dts audio would have severe stutter and/or lip sync issues. So far the 12/2016 build seems to be pretty much rock solid for 3D mvc playback. However, this build does have a problem in my setup. The gui and bluray mkv files are not displaying with the correct AR. There is a little portion of both the left and right side of the screen that has black bars,that should not be there. I have tried changing the fps/frequency and sometimes this will get the gui interface to remove the left/right thin black bars, but once a bluray rip is started they return, and usually the gui has them also. This problem happens with 3D & non 3D mkv files however, the problem in 3D movies is noticed less even though its there. One last note, not sure if it means anything, but a sampling of a few of the hdddvd mkv files have shown those are displaying correctly without the thin bars on the left & right sides of the screen. Just to make sure its not my avr, bypassed it and connected the display directly to the ap34, but same problem. This problem is not seen when watching television with the mythTV add-on, that content is displayed fine. The television is a 2016 LG 65" OLED. Any suggestions?
Thanks.
Posts: 2,510
Joined: Dec 2012
Reputation:
216
1st on the list was fulfilled years ago. It just wasn't an NUC.