[PhilMcK]

Hi,

My setup is as follows:
XBMC 10.1, Mac OS X 10.6.7
Audio connected by TOSLINK to a Sherwood amp

I'm trying out XBMC 10.1 after using the older version for a long time. My problem is this:

When playing a DTS/AC3 movie, the amp switches correctly and all is good. If I pause playback for more than (say) 10 seconds, the amp switches out of DTS/AC3 mode to 'Stereo'. When I resume playback, the amp switches to 'Multi PCM' instead of the correct AC3/DTS mode and the audio is all ghostly and weird. I tested this with the older version of XBMC and the behaviour is different. When I pause a movie there, the amp stays in DTS/AC3 mode for as long as the show is paused - so resuming playback is good.

Any ideas?

Phil.

[PhilMcK]

I tried a nightly build - same result. Does no-one else have a similar problem? This is driving me nuts!

[s1lang]

I have this too

[Ned Scott]

No logs = no help.

[PhilMcK]

I tried the latest daily this morning - same issue. Los attached this time! You'll see a play,pause for 'Alice in Wonderland' at the end of the log.

Log here: http://pastebin.com/h7WESSXt