2012-03-13, 11:27
(2012-03-10, 12:08)beta-j Wrote:bobo1on1 Wrote:The channels in boblight.conf don't match the arduino pins, you should use channels 4, 5 and 6 as shown in the howto.
Also, set hscan to 0 100 since it's the only light you have.
So if i'm understanding correctly - since I have a single RGB LED strip, the number of channels in boblight.conf should be 3 and it should use channels 1,2 and 3 no?
I tried setting it with 6 channels and using 4,5 and 6 as well as 3 channels using 1,2 and 3 but no luck so far.
25 leds are 75 channels, 50 leds are 150 channels and so on
how many leds do You have on that strip?