[Bighampton]

Wifi still broken for me. I'm using the Edimax EW-7811u (RTL8188cus chipset), RPi Model B 512MB (256/256)

# dmesg

...

[ 56.053858]
[ 56.053858] rfpwrstate_check call ips_leave....
[ 56.053886] ==>ips_leave cnts:2
[ 56.053892] ===> rtw_ips_pwr_up..............
[ 56.053907] ===> ips_netdrv_open.........
[ 56.062839] ===> FirmwareDownload91C() fw:Rtl819XFwImageArray_TSMC
[ 56.062865] FirmwareDownload92C accquire FW from embedded image
[ 56.062876] fw_ver=v80, fw_subver=0, sig=0x88c0
[ 56.109239] fw download ok!
[ 56.109262] Set RF Chip ID to RF_6052 and RF type to 1T1R.
[ 56.516620] IQK:Start!!!
[ 56.528103] Path A IQK Success!!
[ 56.536364] Path A IQK Success!!
[ 56.541362] IQK: final_candidate is 0
[ 56.541384] IQK: RegE94=101 RegE9C=b RegEA4=ff RegEAC=1 RegEB4=0 RegEBC=0 RegEC4=0 RegECC=0
[ 56.541384] Path A IQ Calibration Success !
[ 56.653385] pdmpriv->TxPowerTrackControl = 1
[ 56.658371] MAC Address from REG_MACID = XX:XX:XX:XX:XX:XX
[ 56.658386] rtl8192cu_hal_init in 600ms
[ 56.658440] <=== rtw_ips_pwr_up.............. in 600ms
[ 56.658633] ==> ips_leave.....LED(0x00028080)...
[ 56.658650] IW_SCAN_THIS_ESSID, ssid=Bighampton, len=10
[ 57.775156] survey done event(13)
[ 57.782454] wpa_set_auth_algs, AUTH_ALG_SHARED_KEY and AUTH_ALG_OPEN_SYSTEM [value:0x3]
[ 57.782484] set_mode = IW_MODE_INFRA
[ 57.783599] =>rtw_wx_set_essid
[ 57.783621] ssid=Bighampton, len=10
[ 57.783639] Set SSID under fw_state=0x00000008
[ 57.783651] desired_encmode: 0, privacy: 0
[ 57.783659] rtw_select_and_join_from_scanned_queue: return _FAIL(candidate == NULL)
[ 57.783683] <=rtw_wx_set_essid, ret 0
[ 57.784205] Set BSSID under fw_state=0x00000808
[ 58.905174] survey done event(d)
[ 58.905210] desired_encmode: 0, privacy: 0
[ 58.905221] rtw_select_and_join_from_scanned_queue: return _FAIL(candidate == NULL)
[ 58.905229] try_to_join, but select scanning queue fail, to_roaming:0
[ 59.779432] ==>pwr_state_check_handler .fw_state(8)
[ 59.779457] ==> rtw_ps_cmd , enqueue CMD
[ 59.779492] ==>rtw_ps_processor .fw_state(8)
[ 59.779502] ==>ips_enter cnts:3
[ 59.779661] ==>power_saving_ctrl_wk_hdl change rf to OFF...LED(0x00028000)....
[ 59.779661]
[ 59.779675] ===> rtw_ips_pwr_down...................
[ 59.780012] ====> rtw_ips_dev_unload...
[ 59.807349] usb_read_port_cancel
[ 59.807461] usb_write_port_cancel
[ 59.807530] ==> rtl8192cu_hal_deinit
[ 59.807538] bkeepfwalive(0)
[ 59.807543] card disble without HWSM...........
[ 59.813399] <=== rtw_ips_pwr_down..................... in 30ms


# ifconfig

eth0 Link encap:Ethernet HWaddr XX:XX:XX:XX:XX:XX
inet addr:192.168.0.215 Bcast:192.168.0.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:264 errors:0 dropped:0 overruns:0 frame:0
TX packets:242 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:20537 (20.0 KiB) TX bytes:83744 (81.7 KiB)

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:6 errors:0 dropped:0 overruns:0 frame:0
TX packets:6 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:426 (426.0 B) TX bytes:426 (426.0 B)

wlan0 Link encap:Ethernet HWaddr XX:XX:XX:XX:XX:XX
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)


# lsmod
Module Size Used by
8192cu 525379 0

Looks like no change from 12253.