2013-12-17, 12:08
Ah yeah, of course. How frustrating!
(2013-12-16, 21:12)millercentral Wrote: Just a heads up that I ran into an issue with the r16530 nightly. I use the "Wait for network to start before booting" setting in OE, and with this nightly applied it never gets past that OE splashscreen waiting for the network (keeps showing the "will wait a maximum of 10 seconds" message over and over again).
I know they are nightlies and not expected to be bugfree, but wanted to let others know in case they get into the same spot.
(2013-12-17, 09:28)Settepotet Wrote: I'm at work now, so have not tried it.
As far as i understand it's as simple as set the jumper to configuration mode, insert a USB stick with the *.bio file and boot it up. And then wait for 10 mins. It should take 3-4 minutes, but since we don't se the screen I'l give it 10 minutes. If it requires some key presses I guess some good soul on this site would provide with the correct info...? I will first try the Mini DP, but if that don't work a bios update is my last resort.
I'm positive that the NUC works fine, since it boots up normally. No flashing leds, and USB devices light up too. But the HDMI is the issue, I hope.
I was looking so much forward to this unit, so it bugs me that it won't work. So much for being an early consumer.
cat /proc/acpi/wakeup
lspci
GLAN S4 *enabled pci:0000:00:19.0 00:19.0 Ethernet controller: Intel Corporation Device 1559 (rev 04)
EHC1 S4 *enabled pci:0000:00:1d.0 00:1d.0 USB controller: Intel Corporation Device 9c26 (rev 04)
XHC S4 *enabled pci:0000:00:14.0 00:14.0 USB controller: Intel Corporation Device 9c31 (rev 04)
PWRB S3 *enabled
dmesg
[64538.809321] e1000e 0000:00:19.0 eth0: PHY Wakeup cause - Magic Packet
(2013-12-17, 12:36)d_hero Wrote: Strange, I need to use this setting too as without it, my SQL library has not connected when Openelec/xbmc boots up, so I set a 5 sec wait for network and had this running on 16519 and now 16559 and no problems at all. It pauses for 5 seconds or less at the Openelec splash and then continues to boot and works flawlessly.