2015-09-01, 14:42
(2015-08-23, 15:33)p_turner_uk Wrote:(2015-04-29, 09:13)raymw Wrote: With the pin shorting technique I have noticed that nothing happens even holding the shorting pins and the reset button in for a couple of minutes BUT if you then simply remove the pin shorting and reset button, power off the box and reboot still with the boot SD card in and just the reset button held in (no need to short the pins again this time) then you will get into old normal recovery mode. Then simply reboot with the Ember convert file set SD card in instead and of course just the reset button held in for 10-15 seconds in the normal way and bingo you have Ember V1.0.0
Sorted it out...... exactly how raymw said in the above quoted post.... thanks!
So I put Ember 1.0 on my box and then it went wonky so I decided that
I would put mx linux back on it.
I bricked it and have tried many things to get the boot screen up that
were suggested in the post.
Here's what I have been trying lately:
I have a black screen.
I bridged the pins and hold in reset for 2 mins, with the empty boot disk in.
Turn off.
Restart the box with just the reset button pressed and the empty boot
disk for 15 to 20 seconds. I get nothing.
I still have a black screen.
Should I just keep trying or try something else?
