[vtecatalan]

Check your PM's vtecatalan. Odd that you cannot send PMs but I have given you my email address in the PM so you can reply that way

Hello Ray,

Good News (I hope…)

This morning, I tried one last test.
I formatted one SDCard 2 GB with sdmaker.exe and I copied this “official“ mygica firmware inside.
ATV1200/520 4.2 Ver: 20140519 spi+bootTamaño: 252MBFecha versión: 19/05/2014

Now the box boot, but not move from android system recovery.

I have used the "wipe data/ factory reset" option but it immediately boots into recovery mode again.
Is possible that the internal flash memory has become corrupted?

As can I now proceed, first to verify that the unit is OK and then to install Ember?

Thanks.

The unbricking has occurred and from the uboot file you installed with making the SD card utility. So as it will now boot into recovery it should now install teh EmbER V3.0.1 public version of EmbER okay. Once installed you can register, activate and use the OTA update to EmbER 4. Enjoy.

Glad it has worked out for you but let us know that indeed you can now install EmbER okay.

Hello again,

After a busy days, I was able to recover this topic .

As I mentioned , I retrieve my box ATV1200 and could reach the android system recovery.
From here, I could install multiple versions of Linux, such as two versions of Mygica: review 20130805 and review: 20131214.
However, when I install ember version 3.01, the installation process appears to start properly, but when reboot after installing fixed red LED (bricked again) and I have to restart the process unbrick.
Why can this happen?

I remember I first tried an old version of Ember that worked well. How I can download any older versions of Ember for testing?

Thanks.