[avig]

Once I upgraded to 12.3 my Yatse android remote stopped working. Is there a solution for it?
Thanks,
Avi

[fahmed]

I have noticed the same thing. I have four installations of Frodo that were running on 12.2
Yatse is installed on three Android devices to control these XBMC installs, I use a MySQL database for a shared library setup. All was working well until I decided to upgrade all to 12.3 on Saturday night.

Firstly the Music library disappeared and I needed to rescan the music sources but more annoyingly Yatse does not work on any 12.3 installation.

I have had to resort to the official XBMC remote which is poor in comparison.

[mildenhall]

I can't comment for 12.3, however yatse works fine for me on Gotham. Try one of the development builds. I use linux PCs and raspberry pis for my media centre.

[mayoman]

It's most likely the update has just messed with the XBMC share. Double check that XBMC is still allowing control using your share method (http?) & that the settings have not been changed (e.g. from port 80 to port 8080). Then try to initiate a new host with Yatse.
Failing that, get a Yatse debug log & submit a post with a link to the log in the Yatse support thread. Tolriq is usually very responsive.

[fahmed]

Checked the remote control settings and ports. All looks correct but still can't get Yatse to work with Frodo 12.3
When I get time I'll log a bug report regarding Yatse.

[avig]

My problem was that the XBMC device has changed IP address (allocated a new address by the router) and as a result Yatse couldn't connect.

Since the problem happened with the upgrade to 12.3 I mistakenly linked it to the new version.
Once I changed the IP address on Yatse all is working.

Thanks for the answers.
Avi