OpenELEC Testbuilds for RaspberryPi Part 2
(2013-12-06, 22:53)MilhouseVH Wrote: How far have you got with this? I was able to complete the "modprobe lirc_rpi" step, but of course I don't have anything connect to my GPIO pins so can't go much further.

Its strange, when I run "modprobe lirc_rpi" I can press any one button on the remote and it works. After that no commands from the remote work until a reboot and then I can again press only one button.

In the Add Your Own Remote section, "killall lircd" says that lircd isn't running at all. Then "ir-keytable -p LIRC" returns "Couldn't find any node at /sys/class/rc/rc*." When I run "irrecord /storage/.config/lircd.conf" in this section however, I can see that it is recognizing each key pressed.

Later under troubleshooting, "irw /var/run/lirc/lircd-lirc0" gives me a connection refused error.

The remotes work fine under stock OE as well as rbej's builds, Any further suggestions?


Messages In This Thread
AW: RE: - by DieterLumpen - 2013-07-29, 20:50
include guires switch? - by hpbaxxter - 2013-08-01, 21:46
RE: dual audio?? - by pootler - 2013-08-03, 17:13
Help, watch 3D Film on Non 3D TV - by unix72 - 2013-08-09, 12:39
Remote Controllers - by tfft - 2013-08-14, 09:11
rbej repeatable crash - by RichG - 2013-08-19, 12:43
New Tester - by theneverstill - 2013-10-03, 17:16
RE: OpenELEC Testbuilds for RaspberryPi Part 2 - by pennywisdom - 2013-12-07, 00:24