OpenELEC Testbuilds for RaspberryPi Part 2
(2013-12-11, 18:16)MilhouseVH Wrote: With regards to the setting of the hdmi_ignore_cec property, I presume it's not actually possible for the Pi to determine if CEC is supported (or not) when HDMI is connected? My monitor has no CEC, so the default position would be to ignore CEC in my case.

No. You need quite a bit of protocol to work out the CEC network, and that is done in libCEC.
And the Pi can't really return fail to the initial call just because no CEC device responded immediately.
It may be a TV in standby or on wrong channel didn't respond then, but does later when switched to right channel.


Messages In This Thread
AW: RE: - by DieterLumpen - 2013-07-29, 20:50
include guires switch? - by hpbaxxter - 2013-08-01, 21:46
RE: dual audio?? - by pootler - 2013-08-03, 17:13
Help, watch 3D Film on Non 3D TV - by unix72 - 2013-08-09, 12:39
Remote Controllers - by tfft - 2013-08-14, 09:11
rbej repeatable crash - by RichG - 2013-08-19, 12:43
New Tester - by theneverstill - 2013-10-03, 17:16
RE: OpenELEC Testbuilds for RaspberryPi Part 2 - by popcornmix - 2013-12-11, 18:25