OpenELEC Testbuilds for RaspberryPi Part 2
(2014-03-27, 21:32)SenorLoco Wrote: Well just for fun I tried connecting to my pi again (still haven't been home to reboot) and it did reconnect to wifi at home point. Here is the dmesg http://sprunge.us/dYhO

OK so it is using the recently updated rtl8192cu kernel module.

Code:
[   14.631071] rtl8192cu: Chip version 0x10
[   15.342790] rtl8192cu: MAC address: 80:1f:02:86:e4:fd
[   15.342830] rtl8192cu: Board Type 0
[   15.343031] rtl_usb: rx_max_size 15360, rx_urb_num 8, in_ep 1
[   15.343179] rtl8192cu: Loading firmware rtlwifi/rtl8192cufw_TMSC.bin
[   15.349096] usbcore: registered new interface driver rtl8192cu
[   15.357593] ieee80211 phy0: Selected rate control algorithm 'rtl_rc'
[   15.375720] rtlwifi: wireless switch is on
[   15.523133] smsc95xx 1-1.1:1.0 eth0: hardware isn't capable of remote wakeup
[   15.523900] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[   16.528002] input: lircd as /devices/virtual/input/input0
[   16.674516] rtl8192cu: MAC auto ON okay!
[   16.972203] rtl8192cu: Tx queue select: 0x05
[   18.131949] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready

However when it tries to authenticate with your Access Point, it times out, eventually connecting 325 seconds later.

Code:
[   19.962060] wlan0: authenticate with bc:ae:c5:c4:f0:d3
[   19.991210] wlan0: send auth to bc:ae:c5:c4:f0:d3 (try 1/3)
[   20.094325] wlan0: send auth to bc:ae:c5:c4:f0:d3 (try 2/3)
[   20.197757] wlan0: send auth to bc:ae:c5:c4:f0:d3 (try 3/3)
[   20.301029] wlan0: authentication with bc:ae:c5:c4:f0:d3 timed out
...
[  342.760231] rtl8192cu: MAC auto ON okay!
[  342.816690] rtl8192cu: Tx queue select: 0x05
[  343.368658] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[  345.203139] wlan0: authenticate with bc:ae:c5:c4:f0:d3
[  345.230725] wlan0: send auth to bc:ae:c5:c4:f0:d3 (try 1/3)
[  345.241607] wlan0: authenticated
[  345.244864] wlan0: associate with bc:ae:c5:c4:f0:d3 (try 1/3)
[  345.248054] wlan0: RX AssocResp from bc:ae:c5:c4:f0:d3 (capab=0x411 status=0 aid=5)
[  345.248463] wlan0: associated

then timing out several times much later:
Code:
[ 5222.167250] wlan0: associate with bc:ae:c5:c4:f0:d3 (try 1/3)
[ 5222.269939] wlan0: associate with bc:ae:c5:c4:f0:d3 (try 2/3)
[ 5222.373276] wlan0: associate with bc:ae:c5:c4:f0:d3 (try 3/3)
[ 5222.476655] wlan0: association with bc:ae:c5:c4:f0:d3 timed out
[ 5587.974333] wlan0: authenticate with bc:ae:c5:c4:f0:d3
[ 5587.991192] wlan0: send auth to bc:ae:c5:c4:f0:d3 (try 1/3)
[ 5588.093203] wlan0: send auth to bc:ae:c5:c4:f0:d3 (try 2/3)
[ 5588.196566] wlan0: send auth to bc:ae:c5:c4:f0:d3 (try 3/3)
[ 5588.299866] wlan0: authentication with bc:ae:c5:c4:f0:d3 timed out
[ 5953.965413] wlan0: authenticate with bc:ae:c5:c4:f0:d3
[ 5953.987748] wlan0: send auth to bc:ae:c5:c4:f0:d3 (try 1/3)
[ 5954.089793] wlan0: send auth to bc:ae:c5:c4:f0:d3 (try 2/3)
[ 5954.193139] wlan0: send auth to bc:ae:c5:c4:f0:d3 (try 3/3)
[ 5954.296470] wlan0: authentication with bc:ae:c5:c4:f0:d3 timed out

There is discussion about the instability of the rtl8192cu driver here (scroll to the bottom, comments underneath the commits) - any information you can add will help as they seem to be lacking logs.
Texture Cache Maintenance Utility: Preload your texture cache for optimal UI performance. Remotely manage media libraries. Purge unused artwork to free up space. Find missing media. Configurable QA check to highlight metadata issues. Aid in diagnosis of library and cache related problems.


Messages In This Thread
RE: OpenELEC Testbuilds for RaspberryPi Part 2 - by Milhouse - 2014-03-27, 22:31
AW: RE: - by DieterLumpen - 2013-07-29, 20:50
include guires switch? - by hpbaxxter - 2013-08-01, 21:46
RE: dual audio?? - by pootler - 2013-08-03, 17:13
Help, watch 3D Film on Non 3D TV - by unix72 - 2013-08-09, 12:39
Remote Controllers - by tfft - 2013-08-14, 09:11
rbej repeatable crash - by RichG - 2013-08-19, 12:43
New Tester - by theneverstill - 2013-10-03, 17:16