2014-07-08, 19:26
(2014-07-08, 18:41)jmhenry5150 Wrote:(2014-07-08, 16:44)Matt Devo Wrote: perhaps your output isn't on HDMI1, but on HDMI0? there's nothing wrong with the syntax of the command
Werid, I ran this and got a different error:
MediaRoom:~ # xrandr --output HDMI0 --set "Broadcast RGB" "Full"
warning: output HDMI0 not found; ignoring
X Error of failed request: BadRROutput (invalid Output parameter)
Major opcode of failed request: 139 (RANDR)
Minor opcode of failed request: 15 (RRGetOutputProperty)
Serial number of failed request: 36
Current serial number in output stream: 36
then the display output selection isn't the issue apparently. BTW, it's helpful if you quote only the relevant part of a post, rather than the entire thing - much easier to read/reply to.