2016-01-05, 12:35
Hello maikito26,
Just a few words to express my feelings : I am fond of this add-on, it is very useful. I think I'll use it quite often
(Congratulations from my wife, too.)
I have an old Foscam SD (model FI8918W).
So far so good : configuration is OK, I can watch the stream fullscreen without any problem.
I can also launch a picture-in-picture preview at any time, since I mapped a XBMC.RunPlugin action to some button in Yatse remote on my Android phone.
The only thing that doesn’t seem to work is motion and sound detection : it never pops up the preview automatically…
Motion detection is activated, sound also, and service is started.
Tonight I’ll upload a Kodi log. I hope you will be able to troubleshoot my problem.
Is Surveillance Room supposed to write something specific in the log upon detection, or do I have to activate debug mode ?
What kind of string do I have to expect if motion (or sound) is detected ?
Just a few words to express my feelings : I am fond of this add-on, it is very useful. I think I'll use it quite often
(Congratulations from my wife, too.)
I have an old Foscam SD (model FI8918W).
So far so good : configuration is OK, I can watch the stream fullscreen without any problem.
I can also launch a picture-in-picture preview at any time, since I mapped a XBMC.RunPlugin action to some button in Yatse remote on my Android phone.
The only thing that doesn’t seem to work is motion and sound detection : it never pops up the preview automatically…
Motion detection is activated, sound also, and service is started.
Tonight I’ll upload a Kodi log. I hope you will be able to troubleshoot my problem.
Is Surveillance Room supposed to write something specific in the log upon detection, or do I have to activate debug mode ?
What kind of string do I have to expect if motion (or sound) is detected ?