[MikeKL]

With others already posting reports is it still useful to provide specific debug details?

There is a tweak to CEC cleanup 13 that will be in tonight's build.
There have been a few different symptoms reported, so I'm not sure it will be a complete fix, but hopefully will resolve some user's issues.

So test with tonight's build. To ensure consistent results I'd recommend powering off the TV from the mains for a minute after updating the build and before testing.

If you still have problems with tonight's build then logs would be useful. Add to config.txt

Code:

logging_level=0x230000

Reboot and confirm CEC remote works and then grab the log:

Code:

vcdbg log msg 2>&1 | pastebinit

Then do whatever it that provokes unwanted behavior (e.g. TV powers on unwantedly) and grab another log.

OK installed #0201 and clean booted into rpi2 then grabbed log file with logging level set in config.txt (as requested) after using tv remote to control kodi etc. http://sprunge.us/aQdf

Then using receiver remote I switched to another hdmi device connected to avr receiver, switched back to rpi2 and was still able to control kodi with tv remote. Then I switched off the TV (which also switches off the avr reciever)

Few moments later, switched on tv with tv remote and once tv and avr receiver powered up, tried unsuccessfully to wake up kodi (focused hdmi device) via TV remote
(Operating OK button on tv remote, operates a TV function rather than confirming a wake up of kodi via pressing OK button, which would normally be expected to occur)

I then attempted to wake up kodi with bluetooth keyboard to see if once awake tv remote would then control kodi normally and this appears to provoke a crash of kodi (so unable to test if remote was successfully controlling kodi or not during this test)

kodi debug crashlog

Hope explanation of test performed "as far as I got through requested test" with information gathered is of some use?

In the past (Krypton builds..) I could always wake up kodi from remote if tv and receiver switched on and focused on using rpi2 kodi device.
With more recently LibreELEC builds always needed to use bluetooth keyboard to perform wake up from idle of kodi and then TV remote could take over control of kodi.

----edit----

OK, switched to another device when kodi GUI still visible on TV but in an idle state (tv screen dimmed) and when switching back to kodi was not able to wake up device (In fact trying to use up/down keys on remote "which normally use to know where i am in kodi when waking up" causes kodi GUI to move up and down on TV screen? Seen this before occasionally, but not been able to re-produce reliably)

CEC log http://sprunge.us/iIXh