v18 LibreELEC Testbuilds for RaspberryPi (Kodi 18.0)
(2017-09-08, 01:12)Milhouse Wrote:
(2017-09-08, 01:08)skyliner2 Wrote: I used to control my Raspy with my Logitech IR remote (MCE commands), but it doesn't work anymore since about 1 month. Sad Is there any solution available?

Try disabling LIRC if you have that enabled. Hard to say what happened "about 1 month" ago that might cause this, as the LIRC changes have been in way longer than that (2-3 months). You could always try and determine the build.

I'm using Hifi Digi+, customise lircd.conf of IR remote in /storage/.config and setting following work fine (build #907):
In config.txt (use GPIO PIN 26):
dtoverlay=gpio-ir,gpio_pin=26
dtoverlay=hifiberry-digi
In Settings > LibreELEC > Services > Lirc: enable
Lirc disabled not work.


Messages In This Thread
WD MyCloud - by crisp waffles - 2017-09-06, 03:11
RE: LibreELEC Testbuilds for RaspberryPi (Kodi 18.0) - by TVPL - 2017-09-08, 12:12
No 3D Playback since Version - by Mike74 - 2017-10-09, 19:25
Migrating from RPi2 to RPi1 - by RappaSan - 2017-11-10, 14:45
RE: Migrating from RPi2 to RPi1 - by Milhouse - 2017-11-10, 21:06
RE: Migrating from RPi2 to RPi1 - by RappaSan - 2017-11-11, 09:17
Resolution broken after 0415 - by lozbrown85 - 2018-04-20, 11:48
popt 1.16 - by n0n4m3 - 2018-06-29, 00:28
RE: popt 1.16 - by Milhouse - 2018-06-29, 06:39
A plugin to be resurrected - by ArminiusTux - 2018-10-22, 22:02
RE: A plugin to be resurrected - by Milhouse - 2018-10-23, 02:46
Logout Mark Read Team Forum Stats Members Help
LibreELEC Testbuilds for RaspberryPi (Kodi 18.0)24