Thread Closed
v18 LibreELEC Testbuilds for x86_64 (Kodi 18.0)
Output with #1111 (works perfect)

Found /sys/class/rc/rc0/ (/dev/input/event8) with:
Driver ite-cir, table rc-rc6-mce
Supported protocols: lirc rc-5 rc-5-sz jvc sony nec sanyo mce_kbd rc-6 sharp xmp
Enabled protocols: lirc nec rc-6
Name: ITE8708 CIR transceiver
bus: 25, vendor/product: 1283:0000, version: 0x0000
Repeat delay = 500 ms, repeat period = 125 ms

Output with #1113 (double Key-input

LivingRoom:~ # ir-keytable
Found /sys/class/rc/rc0/ (/dev/input/event8) with:
Driver ite-cir, table rc-rc6-mce
Supported protocols: lirc rc-5 rc-5-sz jvc sony nec sanyo mce_kbd rc-6 sharp xmp
Enabled protocols: lirc nec rc-6
Name: ITE8708 CIR transceiver
bus: 25, vendor/product: 1283:0000, version: 0x0000
Repeat delay = 500 ms, repeat period = 125 ms



This "Then run ir-keytable -t, press a button for a short time, wait a second or two, then press another button for a bit longer (1 or 2 seconds). Post the output you got on the console, it should look like that:
Code:" has no effect to my system
  Thread Closed
 
Thread Rating:
  • 24 Vote(s) - 4.5 Average


Messages In This Thread
RE: LibreELEC Testbuilds for x86_64 (Kodi 18.0) - by pacoma2610 - 2017-11-14, 14:46