Thread Closed
v18 LibreELEC Testbuilds for x86_64 (Kodi 18.0)
(2017-12-06, 21:10)laric Wrote:  Thanks, that helped a lot. And nearly there. But I get some repeat.. like every second or third input is interpreted twice. Any advice on how to get around that one? tried adding -r 150 to the options to reduce the key repeat but didn't do any difference. 
Use ir-keytable to configure the repeat delay and period. The default delay of 500ms is usually OK but increasing it a bit (eg to 750ms) might help with slow fingers Smile If you are using a harmony remote make sure that command repeat isn't set too high - 1 repeat with the default ~100-120ms repeat interval is usually OK.

Use evtest to test if the devinput events repeat at your desired rate (check for EV_KEY events). Also use irw on the inputlircd socket to check if inputlircd works correct (it should generate lirc events the same way as it receives devinput events).

so long,

Hias
  Thread Closed
 
Thread Rating:
  • 24 Vote(s) - 4.5 Average


Messages In This Thread
RE: LibreELEC Testbuilds for x86_64 (Kodi 18.0) - by HiassofT - 2017-12-06, 21:59