Thread Closed
v18 LibreELEC Testbuilds for x86_64 (Kodi 18.0)
(2018-04-06, 19:12)BoKKeR Wrote:
(2018-04-06, 05:22)fritsch Wrote:
(2018-04-05, 22:24)BoKKeR Wrote: I run Kodi in [email protected] and I don't think its a heat issue.

here are my measurements:

Code:
/sys/class/thermal/thermal_zone*/temp output
normal
68c
53c

After echo 750 > /sys/kernel/debug/dri/0/i915_min_freq
71c
56c

Its stable.
 It absolutely makes no sense that it gets slower after setting the minimal frequency to 750. Normal minimum is 200. 750 will just make sure it does not reduce the clock.  
 I understand that it makes no sense. At best setting the frequency did not help anything. The temperatures are almost the same and the framerate is the same-ish rubbish. I could post a video tomorrow if it would help anything but I doubt it will. Is it only my NUC6CAYH that is having these troubles with 10bit 4k video on the newest builds?  @blokkie  ?? 
 Videos in general don't help. Debug Log does.
First decide what functions / features you expect from a system. Then decide for the hardware. Don't waste your money on crap.
  Thread Closed
 
Thread Rating:
  • 24 Vote(s) - 4.5 Average


Messages In This Thread
RE: LibreELEC Testbuilds for x86_64 (Kodi 18.0) - by fritsch - 2018-04-07, 08:43