2011-12-04, 01:46
Forsaken Wrote:This is the output, its connected to a Onkyo 709.
***** /proc/asound/card0/eld#3.0 *****
monitor_present 1
eld_valid 1
monitor_name
connection_type HDMI
eld_version [0x0] reserved
edid_version [0x0] no CEA EDID Timing Extension block present
manufacture_id 0x0
product_id 0x0
port_id 0x0
support_hdcp 0
support_ai 0
audio_sync_delay 0
speakers [0xffff] FL/FR LFE FC RL/RR RC FLC/FRC RLC/RRC FLW/FRW FLH/FRH TC FCH
sad_count 0
It should look more like this: (note the receiver name is specified, and the supported pass-through formats are listed).
My wiring is: hdmi cable from computer to receiver and then hdmi cable from receiver to tv. Did you connect it like that? I can't remember if there's a configuration option in the receiver configuration to allow pass-through, that could also be the problem.
Code:
***** /proc/asound/card1/eld#1.0 *****
monitor_present 1
eld_valid 1
monitor_name TX-SR608
connection_type HDMI
eld_version [0x2] CEA-861D or below
edid_version [0x3] CEA-861-B, C or D
manufacture_id 0xcb3d
product_id 0xa62
port_id 0x20000
support_hdcp 0
support_ai 0
audio_sync_delay 0
speakers [0x4f] FL/FR LFE FC RL/RR RLC/RRC
sad_count 8
sad0_coding_type [0x1] LPCM
sad0_channels 2
sad0_rates [0x1ee0] 44100 48000 88200 176400 192000 384000
sad0_bits [0xe0000] 16 20 24
sad1_coding_type [0x1] LPCM
sad1_channels 8
sad1_rates [0x1ee0] 44100 48000 88200 176400 192000 384000
sad1_bits [0xe0000] 16 20 24
sad2_coding_type [0x2] AC-3
sad2_channels 8
sad2_rates [0xe0] 44100 48000 88200
sad2_max_bitrate 640000
sad3_coding_type [0x7] DTS
sad3_channels 8
sad3_rates [0xc0] 48000 88200
sad3_max_bitrate 1536000
sad4_coding_type [0x9] DSD (One Bit Audio)
sad4_channels 6
sad4_rates [0x40] 48000
sad5_coding_type [0xa] E-AC-3/DD+ (Dolby Digital Plus)
sad5_channels 8
sad5_rates [0xc0] 48000 88200
sad6_coding_type [0xb] DTS-HD
sad6_channels 8
sad6_rates [0x1ec0] 48000 88200 176400 192000 384000
sad7_coding_type [0xc] MLP (Dolby TrueHD)
sad7_channels 8
sad7_rates [0x1480] 88200 192000