2015-04-27, 22:13
Hi,
I have installed TVHeadend (v 3.4.27) on a Arch Linux pc, with a DVBsky T9580 v3 receiver.
In the "DVB Inputs" section of the configuration page in the web interface, the two receivers of the board are displayed, but after selecting the proper DVB network nothing happens (no initial scan, no anything) for each receiver.
Even if the receivers are displayed, the kernel modules are not loaded on TVHeadend start. If I start w_scan or VDR, the modules are loaded correctly and the receivers work (I can watch channels in Kodi with VDR), but if I stop these services and I restart TVHeadend, nothing changes: no scan is done by TVHeadend.
How can I understand what is preventing the receivers to work with TVH?
Thanks
I have installed TVHeadend (v 3.4.27) on a Arch Linux pc, with a DVBsky T9580 v3 receiver.
In the "DVB Inputs" section of the configuration page in the web interface, the two receivers of the board are displayed, but after selecting the proper DVB network nothing happens (no initial scan, no anything) for each receiver.
Even if the receivers are displayed, the kernel modules are not loaded on TVHeadend start. If I start w_scan or VDR, the modules are loaded correctly and the receivers work (I can watch channels in Kodi with VDR), but if I stop these services and I restart TVHeadend, nothing changes: no scan is done by TVHeadend.
How can I understand what is preventing the receivers to work with TVH?
Thanks