2014-02-17, 17:06
@turt
I know how you feel, I struggled with this also quite some time over the last week. This is a D34010WKY.
The 3,3V pin (https://www.pulse-eight.com/store/download/get/28) doesn't seem to provide enough power to supply the board. I just connected it to the 3,3V PIN of the SATA power connector, works flawless so far.
Had also a cheap mini HDMI cable which doesn't connected the CEC signal properly. Just bought another one and this one is working fine. Keep that in mind if you get it to work and it does not show any devices on the bus.
Good luck...
I know how you feel, I struggled with this also quite some time over the last week. This is a D34010WKY.
The 3,3V pin (https://www.pulse-eight.com/store/download/get/28) doesn't seem to provide enough power to supply the board. I just connected it to the 3,3V PIN of the SATA power connector, works flawless so far.
Had also a cheap mini HDMI cable which doesn't connected the CEC signal properly. Just bought another one and this one is working fine. Keep that in mind if you get it to work and it does not show any devices on the bus.
Good luck...