2014-04-14, 17:54
I'm sort of stumped here as well. I'm guess after reading through this forum thread I'm a bit confused.
I started with a fresh install of Frodo 12.2 (i think) yesterday and go it up in running (using an ION board with Atom processor). I then installed the BlueCop Repo and the Amazon add on. After adding my Amazon username and password it connected right away and I can browse everything just fine. But when I click on any video it begins to stream it quits and gives me an error.
So after searching XBMC forums I found this thread, but I'm not sure this will correct my issue.
Any suggestions? Is the plugin I'm using no longer supported?
SCF
I started with a fresh install of Frodo 12.2 (i think) yesterday and go it up in running (using an ION board with Atom processor). I then installed the BlueCop Repo and the Amazon add on. After adding my Amazon username and password it connected right away and I can browse everything just fine. But when I click on any video it begins to stream it quits and gives me an error.
So after searching XBMC forums I found this thread, but I'm not sure this will correct my issue.
Any suggestions? Is the plugin I'm using no longer supported?
SCF