2015-10-19, 16:21
I tried going back to firmware v1.0.9 earlier and had trouble with my Q5 not rebooting (just stuck on HiMedia logo). Will try again.
Anyway, some good news. All 23.976 2D does play back in proper 2D with latest v3.0.1.1 firmware. Earlier, had my Q5 connected to Onkyo NR636 AVR, to projector, and the Onkyo was the problem. Bad Onkyo and improper HDMI EDID passing, even when set to 'through' w/o any video processing. This was what was causing all my Kodi UI blanking out issues with Raspberry Pi2. Had thought it was the Pi at fault for months; never suspected my AVR. Have a new (Denon) AVR on the way.
However, even with Q5 connected directly to projector, all 23.976 3D is being played at 24.000. And, this is what's causing the microstutters and slight speed-up issues. You don't see any such issues with 2D.
Anyway, some good news. All 23.976 2D does play back in proper 2D with latest v3.0.1.1 firmware. Earlier, had my Q5 connected to Onkyo NR636 AVR, to projector, and the Onkyo was the problem. Bad Onkyo and improper HDMI EDID passing, even when set to 'through' w/o any video processing. This was what was causing all my Kodi UI blanking out issues with Raspberry Pi2. Had thought it was the Pi at fault for months; never suspected my AVR. Have a new (Denon) AVR on the way.
However, even with Q5 connected directly to projector, all 23.976 3D is being played at 24.000. And, this is what's causing the microstutters and slight speed-up issues. You don't see any such issues with 2D.
