2010-06-03, 01:15
tusko Wrote:Hope this response is included before the forum freeze. I use the following command lines for mencoder in linux.
Hi Tusko,
This is brilliant - I'll give it a try!
However, on an older post I was told by Funkytown that Mencoder doesn't support DivX, only Xvid. The difference is that DivX supports a max. peak bitrate whereas Xvid doesn't and will peak above the max. rate you set.
I can't work out from your options which codec you're using. Is it definitely DivX and do your encodes definitely not peak over 6300 bps?