2008-05-20, 17:56
Hi there,
I just tried the same steps I take normally to get the orig xbox remote working in gutsy with xbmc. However something of course has changed and it no longer works.
/var/log/messages :
------------------------------------------------------------------------------------------------------------------------------
/var/log/dmesg :
--------------------------------------------------------------------------------------------------------------------------------
I found a similar post about getting the regular controller working, which a custom driver was supplied. I just was not sure if this was the same issue. So I didn't want to clutter up someone elses thread.
Here is that other thread: http://forum.xbmc.org/showthread.php?tid=33376
Any help of course would be most grateful. Maybe I am just missing something simple... I have everything else working just perfect...
Thanks for your time.
I just tried the same steps I take normally to get the orig xbox remote working in gutsy with xbmc. However something of course has changed and it no longer works.
/var/log/messages :
Code:
May 20 08:45:01 xbmedia-desktop kernel: [ 625.692345] usb 2-2: USB disconnect, address 3
May 20 08:45:06 xbmedia-desktop kernel: [ 630.164080] usb 2-2: new full speed USB device using ohci_hcd and address 4
May 20 08:45:06 xbmedia-desktop kernel: [ 630.366705] usb 2-2: configuration #1 chosen from 1 choice
May 20 08:45:06 xbmedia-desktop kernel: [ 630.373382] input: Generic X-Box pad as /devices/pci0000:00/0000:00:0b.1/usb2/2-2/2-2:1.0/input/input9
May 20 08:45:06 xbmedia-desktop kernel: [ 630.419522] lirc_atiusb[4]: inbound endpoint not found
------------------------------------------------------------------------------------------------------------------------------
/var/log/dmesg :
Code:
[ 42.647817] input: Generic X-Box pad as /devices/pci0000:00/0000:00:0b.1/usb2/2-1/2-1:1.0/input/input6
[ 42.647842] usbcore: registered new interface driver xpad
[ 42.647847] /build/buildd/linux-2.6.24/drivers/input/joystick/xpad.c: X-Box pad driver:v0.0.6
[ 42.693631] lirc_dev: IR Remote Control driver registered, at major 61
[ 42.777415]
[ 42.777418] lirc_atiusb: USB remote driver for LIRC $Revision: 1.61 $
[ 42.777422] lirc_atiusb: Paul Miller <[email protected]>
[ 42.816305] lirc_atiusb[2]: inbound endpoint not found
[ 42.816327] usbcore: registered new interface driver lirc_atiusb
I found a similar post about getting the regular controller working, which a custom driver was supplied. I just was not sure if this was the same issue. So I didn't want to clutter up someone elses thread.
Here is that other thread: http://forum.xbmc.org/showthread.php?tid=33376
Any help of course would be most grateful. Maybe I am just missing something simple... I have everything else working just perfect...
Thanks for your time.