2015-12-01, 17:42
(2015-12-01, 15:26)Roby77 Wrote:(2015-12-01, 15:09)Ipaddle Wrote: Ok, hopefully someone can help me.
Currently using Openelec 7 (Jarvis). Milhouse build 1125.
Everything is fine but the audio signal. I only get PCM input to my receiver.
I have connected my INTEL NUC to a DENON AVR-X2000. And then from my receiver to the TV PHILIPS PFL9704 (see my signature) (via HDMI).
My receiver will not decode that signal to DTS or DD. What is the matter. I am not quite sure that I have understood the issue. But I think my receiver has to decode the signal from PCM to either DTS or DD? Or there should DD or DTS signal coming from the NUC to the DENON receiver. But my receiver gets PCM signal only (checked input signals from HDMI).
My receiver is fully capable decoding those signals. And I had no problems before. Maybe it is some setting that went wrong.
I have of course enabled passthrough option in system.
I am not sure if this is KODI, Openelev or receiver related. Similar post in Openelec Forum.
xbmclogs.com/pjbjqsdda
Same Avr with asus chromebox no problem
Are you in expert mode ?
edit:are you sure you don't enable direct mode with denon ?
did you try resetting avr cpu ?
Expert mode: Yes
Passthrough enabled.
direct mode enabled on denon receiver: Yes - what else? Receiver says on OSD: Input signal PCM/digital.
Resetting AVR CPU: No, how do you do that?