Posts: 110
Joined: Nov 2008
Reputation:
0
2010-03-27, 23:38
(This post was last modified: 2010-03-27, 23:48 by Th3R00st3r.)
Evanrich..
I have your files loaded. Rebooted and was able to navigate.
While in a video I press |<<(replay) to skipminus and it ends up restarting the video. If I press left on the directional pad while in a video, it skips back 30seconds, which is what I want the |<< button to do. I have scoured the files and don't see where to change it. It's not obvious to me. I look for <skipminus>replay</skipminus> in the Lircmap.xml and it's defined as the replay button, not left. So I am a bit confused.
Any suggestions?
Posts: 110
Joined: Nov 2008
Reputation:
0
Ok thanks, You've been a great help.
I guess it's just a matter of knowing what the commands are (com8, coma) Is there a master list for these codes so we know what they do if we want to re-assign them?
Posts: 110
Joined: Nov 2008
Reputation:
0
what code(kls) com?? did you use for library update?
Posts: 110
Joined: Nov 2008
Reputation:
0
Evanrich,
I have up, down, left, right, and OK working, but nothing else works. I want a button to Update the Library and another to bring up the Settings Menu , but I don't know what com# to use...
Could you post a screen shot of what you have, and not the German one, so I can compare? it would be truly appreciated.
Posts: 110
Joined: Nov 2008
Reputation:
0
2010-04-04, 23:48
(This post was last modified: 2010-04-04, 23:57 by Th3R00st3r.)
Thanks man..I will update it now.. I'm not sure why it wasn't working either, but again I have a Harmony 520 with no A or B button..I will assign it to an additional button..
**Edit**
I notice you have Wake Up set to WAKE, but I don't have that in my list. Is that a direct command to XBMC or should if be like "3e"?
Posts: 40
Joined: Feb 2009
2010-04-16, 23:41
(This post was last modified: 2010-04-16, 23:44 by User 44442.)
I seem to be a little confused about one thing.
I have a Zotac Mag HD box setup with an HP MCE USB receiver plugged in that is able to receive IR signals from remotes.
I have a harmony 550 remote, and i'm trying to configure it like described in this thread.
When I go into the device and customize the keys, i don't get the "mute", "vol+" and "vol-" that's in the screen shot. Should I have this?
Posts: 39
Joined: Aug 2010
Reputation:
0
I know this is thread is a bit old now, but would this also work with a Harmony One remote? I've run out of "buttons" using the mceusb (MCE Media Centre) setting and thought the extra user definable buttons shown on the first page would be useful.
Acer Revo R3610 | 2GB Ram | 160GB HDD
XBMCbuntu Frodo installed to HDD
Logitech Harmony One Remote