Posts: 1,483
Joined: Aug 2010
@babca: Wasn't that a problem with the firmware of the new Sandforce-controllers?
Posts: 578
Joined: Feb 2011
Reputation:
18
Sleep mode works fine on my zacate build - see my signature for details.
Posts: 278
Joined: Oct 2010
Reputation:
0
Have you turned off Hybrid Sleep in the power options?
Posts: 28
Joined: Apr 2011
Reputation:
0
babca
Junior Member
Posts: 28
Yes, that was the first thing I did.
Posts: 292
Joined: Mar 2011
Reputation:
0
HansP
Senior Member
Posts: 292
damn quite hot without fan :d
i think i'm gonna put a 70mm fan on the heatsink ( some 1 here told me it fits in my case and that makes no noise compared to the standard )
Posts: 424
Joined: Mar 2010
Reputation:
13
I'm thinking of getting a copper plate laser-cut to fit over both the chipsets. Users could then put any heatsinks they want on top of the copper plate by drilling/tapping into it.
Any interest in such a venture?
Posts: 424
Joined: Mar 2010
Reputation:
13
do the fan mounting holes line up with the enzotech CNB-R1? I looked at the measurements and it seemed not to?
Also, you need 2 of them obviously?
Posts: 67
Joined: Apr 2011
Reputation:
0
Why is the Zalman NB heat sink better than using the existing heat sink with a disabled fan?
Posts: 67
Joined: Apr 2011
Reputation:
0
What are the E350 hole measurements?
Posts: 424
Joined: Mar 2010
Reputation:
13
I believe it was posted earlier that they were both 45mm, on the MSI board.
Just measured my gigabyte board, they are 50mm chipset and 57mm apu. The stock heatsink is one piece with the fan in the middle.
It has been shown that with stock heatsink with fan removed, most motherboards will reach 90 degrees under load, which is much too hot IMHO. I'm used to watercooled PC's that barely break 30 degrees!