2012-08-07, 09:11
@ Mad Medik: I had about the same problems. Here are the most important commands.
After you cloned the repos you can change the branches with `git checkout Eden-pvr` to change the Eden branch or `git checkout master`for the newest Frodo source.
To check if it's the newest version just run `git status`.
To update you either run `git pull origin Eden-pvr` or `git pull origin master`.
When you don't change the branch but only update the source (git pull ...) I think it's enough to only run `make`. You can then test the build by running xbmc.bin from the directory where you built it. If evereything is running fine you can run `make install` to install the source.
Sometimes you have to run configure as well but usually make tells you if you have to do so.
Bootstrap has to be run only once.
After you cloned the repos you can change the branches with `git checkout Eden-pvr` to change the Eden branch or `git checkout master`for the newest Frodo source.
To check if it's the newest version just run `git status`.
To update you either run `git pull origin Eden-pvr` or `git pull origin master`.
When you don't change the branch but only update the source (git pull ...) I think it's enough to only run `make`. You can then test the build by running xbmc.bin from the directory where you built it. If evereything is running fine you can run `make install` to install the source.
Sometimes you have to run configure as well but usually make tells you if you have to do so.
Bootstrap has to be run only once.