[Specterx]

maybe something with your boblight.conf file. is it set to 300 channels (3 channels per LED)?

Try this calculator for your boblight setup.

be sure to set the column numbers correctly. probably: 32, 20 in your case.

Code:

#config file for adalight from http://www.ladyada.net/make/adalight/

[global]
interface       127.0.0.1
port            19333
#speed            75
#interpolation        1
#saturation        2
#value            6
#threshold        50

[device]
name            ambilight
type            momo
output          "com8"
channels        300
prefix        41 64 61 00 32 67  
interval        20000
rate            115200
debug           off #turn this on to see what it's doing with the serial port

#arduino bootloader runs when opening the serial port for the first time
#delay transmission one second after opening so we don't send shit to the bootloader
delayafteropen    1000000

[color]
name            red
rgb             FF0000

[color]
name            green
rgb             00FF00

[color]
name            blue
rgb             0000FF

you need the code above to be on top of the code you get from that web site calculator. Not sure what the prefix line does. but you do need 300 channels.'

give that a try and see what happens.

also check to make sure that the second string of LEDs is connected in the right direction. check the little arrow on each of the LEDs and make sure the output from your first string is going into the end of the second string where they are going into the arrow direction.